12:5 12 Oval crimping For Cu branching sleeves, the ”h” dimension must be checked. This is done at the maximum height of the crimped oval, preferably with calipers. The measurements are compared to the table below. If the ”h” measurement is exceeded, after a contact crimping, contact the nearest Elpress service centre. See measurement points on the image below. Crimp die table type C sleeves (H-dimensions) C-die No. Sleeve max h mm 5 C6-10 12.5 6 C16-25 15.5 8-9 C25-50 22.0 13 C50-70, C70-95 26.5 15 C95-120 30.8 18 C150-185 44.5 21 C240-300, C23 54.4 Indent crimping For Al terminals, the measurement ”T” must be checked, which is measured at the bottom of the indent that the punch has achieved on the terminal. This is best done with special calipers, contact Elpress if necessary. Compare measured ”T” measurement with table. If the ”T” measurement is exceeded, after indented crimping, contact the nearest Elpress service centre. See measurement points on the image below. Crimp die table type AK/AS (T-measurement) Type AS/AK/AKK Tools AS/AK/AKK Matrix Punch max T mm 16 P13M/TP13M P13D/TP13D 6.8 25 P13M P13D 6.8 35 P20M P20D 10.8 50 P20M P20D 10.8 70 P20M P20D 10.8 95 P25M P25D 13.5 120 P25M P25D 13.5 150 P25M P25D 13.5 150SOLID 13P29M 13P29D 14.3 185 P32M P32D 18.4 240 P32M P32D 18.4 300 P36M P36/40/44D 21.0 300B 13P37M/P2537M 13P37D/P2537D 22.5 400B 13P37M/P2537M 13P37D/P2537D 22.5 400 P40M P36/40/44D 22.8 500B P44M P36/40/44D 24.5 500A P2552M P2552D 31.0 630A P2552M P2552D 31.0 630 W60M W60D 36.0 800 W60M W60D 36.0 1000 W60M W60D 36.0 1200 W70M W70D 41.0
RkJQdWJsaXNoZXIy NTYxNjk=